Step-By-Step Set Up Guide

Getting Started With Your All-In-One Cold Plunge...

 

1. Prior to Installation:

  • The All-In-One Cold Plunge will produce some condensation in cooling and heating functions and should only be installed in water-suitable spaces where moisture and water will not present an issue.
  • Have a licensed electrician set up a weather-protected power point which includes an earth connection for your All-In-One Cold Plunge. (The standard New Zealand socket-outlet includes an earth connection)
  • Do not use extension cords.

2. Position the Tub:

  • Wheel the All-In-One Cold Plunge to your desired location.
  • Rotate the red cog on the feet to secure them in place.

3. Ensure Proper Ventilation:

  • Keep the chiller end of the tub with the vent (air outlet) at least 1000mm away from any walls or objects to ensure proper airflow.
  • Maintain a minimum distance of 500mm from the side vents to any walls or objects.

4. Prepare the Tub:

  • Remove the panel at the end of the tub.
  • Check that both filter housings are securely screwed in.
  • Ensure that the inlet and outlet hose connections are tightly screwed in.
  • Verify that the drain is securely closed.

5. Clean the Tub:

  • Rinse the tub thoroughly.

  • Open the drain, let the water empty, and wipe out the tub.

  • Close the drain securely.

6. Fill the Tub:

  • Fill the tub with water. Ensure the water level is approximately 20 cm higher than the water inlet in the tub.
  • Leave enough room for the water level to rise when you get in.
  • As the tub fills, monitor the water level and check all fittings for leaks.

7. Power Up the Tub:

  • Plug the All-In-One Cold Plunge into a power source and turn it on.
  • Turn on the chiller by pressing the switch icon on the control panel.

8. Initial Operation:

  • The chiller will start with a ticking noise, followed by the pump slowly moving water through the chiller and air out into tub. Once all of the air is removed from the chiller it will begin to smoothly circulate the water.

9. Set the Temperature:

  • Use the + or - icons on the control panel to set your desired water temperature.
  • Check the water flow rate displayed on the control panel; it should be around 20 litres per minute.

10. Monitor the Temperature:

  • The large temperature display shows the current water temperature.
  • The chiller will work until it reaches your set temperature and will then maintain it intermittently to keep the water at a constant temperature.

11. Customise Settings:

  • Tap the settings icon on the control panel to customise your settings.
  • Set the ozone time from 0 to 5 minutes.
  • Ozone sanitation is injected into the water at intervals; 0 minutes turns off the ozone generator, while 5 minutes is the maximum interval duration.
  • For heavy use, set the ozone time to 5 minutes.
  • Adjust other settings as needed.

12. Enjoy:

  • Your All-In-One Cold Plunge is now ready for use. Enjoy!